Difference between revisions of "Budaschnozzle Removal & Replacement"
From RayHarwood
Rayharwood (Talk | contribs) |
Rayharwood (Talk | contribs) m |
||
| Line 29: | Line 29: | ||
#Attach the completed extruder assembly to the Y-axis assembly by sliding the wide-V shaped bottom of the extruder assembly into the similarly-shaped receiving slot, ensuring it is seated all the way down (apply gentle pressure). Insert the remaining bolt and tighten using 2.5mm Allen wrench. (Suggestion: first put the bolt in the extruder assembly, holding in place with the Allen wrench, and then seat the extruder assembly into the receiving slot; then tighten the bolt.) | #Attach the completed extruder assembly to the Y-axis assembly by sliding the wide-V shaped bottom of the extruder assembly into the similarly-shaped receiving slot, ensuring it is seated all the way down (apply gentle pressure). Insert the remaining bolt and tighten using 2.5mm Allen wrench. (Suggestion: first put the bolt in the extruder assembly, holding in place with the Allen wrench, and then seat the extruder assembly into the receiving slot; then tighten the bolt.) | ||
#Re-attach electronic connections, ensuring proper orientation and mating of connectors: | #Re-attach electronic connections, ensuring proper orientation and mating of connectors: | ||
| − | *The Budaschnozzle cable (four wires: two orange, two red) | + | #*The Budaschnozzle cable (four wires: two orange, two red) |
| − | *The extruder stepper motor (four wires: black, green, white/blue, red) | + | #*The extruder stepper motor (four wires: black, green, white/blue, red) |
| − | *The fan (two wires: black and red). | + | #*The fan (two wires: black and red). |
#Reload filament by inserting filament through the top of the extruder assembly and pushing down as far as possible; approximately 3 inches/75mm of filament can be pushed in after initial entry into the aluminum plate of the Budaschnozzle before the filament end “hits bottom” at the actual nozzle. (Note: if a bulb of filament makes this difficult, snip off some filament with scissors at the point where the filament is the proper diameter.) | #Reload filament by inserting filament through the top of the extruder assembly and pushing down as far as possible; approximately 3 inches/75mm of filament can be pushed in after initial entry into the aluminum plate of the Budaschnozzle before the filament end “hits bottom” at the actual nozzle. (Note: if a bulb of filament makes this difficult, snip off some filament with scissors at the point where the filament is the proper diameter.) | ||
#Re-latch the idler assembly by raising the screw assembly, pushing the idler plate flush with the filament and hobbed bolt assembly, then slipping the screw assembly down over the idler plate. (Note: it might be necessary to loosen the screw assembly, but then re-tighten.) | #Re-latch the idler assembly by raising the screw assembly, pushing the idler plate flush with the filament and hobbed bolt assembly, then slipping the screw assembly down over the idler plate. (Note: it might be necessary to loosen the screw assembly, but then re-tighten.) | ||
