Difference between revisions of "Budaschnozzle Removal & Replacement"
From RayHarwood
Rayharwood (Talk | contribs) m |
Rayharwood (Talk | contribs) |
||
| Line 25: | Line 25: | ||
#Place the Budaschnozzle on the extruder assembly back plate, ensuring that the Budaschnozzle wire is facing you and not caught between the Budaschnozzle and the assembly back plate. | #Place the Budaschnozzle on the extruder assembly back plate, ensuring that the Budaschnozzle wire is facing you and not caught between the Budaschnozzle and the assembly back plate. | ||
#Place the 2 large bolts in place from underneath the extruder assembly back plate. Hold those in place with one hand, and with the other hand, place the filament motor/gear assembly, aligning the holes with the bolts. You may have to jiggle the filament motor/gear assembly to get the bolts to line up, initially or during tightening. | #Place the 2 large bolts in place from underneath the extruder assembly back plate. Hold those in place with one hand, and with the other hand, place the filament motor/gear assembly, aligning the holes with the bolts. You may have to jiggle the filament motor/gear assembly to get the bolts to line up, initially or during tightening. | ||
| − | #Carefully tighten the bolts using the 3mm Allen wrench; be careful to start the bolt in the thread of the nut with gentle pressure, as it is possible to push too hard, causing the | + | #Carefully tighten the bolts using the 3mm Allen wrench; be careful to start the bolt in the thread of the nut with gentle pressure, as it is possible to push too hard, causing the nut to fall out of the filament motor/gear assembly. |
#Affix the fan to the filament motor/gear assembly using 2 small bolts and washers, tightening with the 2.5mm Allen wrench. | #Affix the fan to the filament motor/gear assembly using 2 small bolts and washers, tightening with the 2.5mm Allen wrench. | ||
#Attach the completed extruder assembly to the Y-axis assembly by sliding the wide-V shaped bottom of the extruder assembly into the similarly-shaped receiving slot, ensuring it is seated all the way down (apply gentle pressure). Insert the remaining bolt and tighten using 2.5mm Allen wrench. (Suggestion: first put the bolt in the extruder assembly, holding in place with the Allen wrench, and then seat the extruder assembly into the receiving slot; then tighten the bolt.) | #Attach the completed extruder assembly to the Y-axis assembly by sliding the wide-V shaped bottom of the extruder assembly into the similarly-shaped receiving slot, ensuring it is seated all the way down (apply gentle pressure). Insert the remaining bolt and tighten using 2.5mm Allen wrench. (Suggestion: first put the bolt in the extruder assembly, holding in place with the Allen wrench, and then seat the extruder assembly into the receiving slot; then tighten the bolt.) | ||
